本文へスキップ

AUTEX Inc. is professional manufacturer of light curing resin.

ParqitAdhesive (Optical cured resin )

○○○○○○○○イメージNewProductOEX-066-X1-3
Autex Inc. has successfully developed the world's first photo latent initiator for cationic photo-polymerization. The photo-polymerization initiator, it can be cured most of the epoxy resin only with light. Curing by heat does not occur. PARQIT is a product name of this polymerization initiator blended solvent-free, one-part-curing epoxy adhesive (trademark registered). We have wide range of products depending on the application. In applications for curing the liquid resin with light, adhesives, coating agents, molding agents, sealing materials, corresponding to the required physical properties. We make choice from variety of catalysts and the resin to provide the most suitable product for each different application. We have 2 types, UV curing and visible light curing its wavelength of sensitivity range is remarkable up to 565nm.
Both UV and visible types are cured only by light.


Visible light curing type
*Polyimide film, any colored materials
*Deep curing property deeper than 10cm, resin casting
*Sealing for liquid crystal cells
*Rapid curing
This type can be cured also by visible lasers, LED or flash strobe!!


UV curing type
*Precise fixture, low shrinkage (below 1%)
*Waveguide
*Temporary bonding
*Antifouling coat
*2 photon absorption resin
*Low outgassing
*Nanoimprint
*Divided irradiation treatment (B-stage)


Products under development

*Heat dissipation material
*High refractive index
*Heat aging resistance material


Custom made : available

Contact us : parqit@autex-inc.co.jp


バナースペース

AUTEX, INC.


Main Office
16-5,tomihisacho,Shinjukuku,Tokyo,162-0067,JAPAN

TEL 81-3-3226-6321
FAX 81-3-3226-6290

Osaka branch
2-1-29,doujimahama,Kitaku,Osaka,530-0004,JAPAN

Technical Center

〒300-1424
4574-1,shimooota,Inashikishi,Ibarakiken,300-1424,JAPAN